Technical Data For Use In Deep-Freeze Warehouses - Securiton ASD 535 Application Manuallines

Technical data for use in deep-freeze warehouses

7 Technical data for use in deep-freeze warehouses
Type
Supply voltage range
Max. power consumption, measured in
Fan speed level V and at 
ASD 535-1 Idle/fault
Alarm I
ASD 535-2 Idle/fault
Alarm I + II
ASD 535-3 Idle/fault
Alarm I
ASD 535-4 Idle/fault
Alarm I + II
additionally with 1 RIM 35 unit
additionally with 2 RIM 35 units
additionally with XLM 35 / SLM 35
additionally with MCM 35
additionally with SIM 35
SMM 535 (not from ASD but rather from PC via USB connection)
Power consumption per sampling point with heating  (at 24 VDC)
Switch-on current peak  (caused by EMC protection elements on the ASD supply input)
Sampling pipe length
Sampling pipe Ø, typical (inner/outer)
Max. number of sampling holes
Sampling hole diameter
Response range
Protection type acc. to IEC 529 / EN 60529 (1991)
Ambient conditions acc. to IEC 721-3-3 / EN 60721-3-3 (1995)
Extended ambient conditions:
• Detector housing temperature range
• Sampling pipe temperature range
• Max. approved temperature fluctuation in detector housing and sampling pipe operation
• Max. permitted storage temperature of detector housing (without condensation)
• Ambient pressure difference of detector housing to sampling pipe (sampling holes)
• Detector housing humidity ambient condition (transient without condensation)
• Humidity ambient humidity (continuous)
Max. loading capacity relay contact
Max. loading capacity per open collector output (electrical strength 30 VDC)
Plug-in terminals
Cable entry for cable Ø
Noise level (at fan speed level III)
Housing material
colour
Approval
Dimensions (W x H x D)
Weight (ASD 535-4, incl. additional modules)
 Power consumption at maximum permitted voltage drop in the electrical installation (guideline value for calcu-
lating the conductor cross-section).
 May cause an immediate actuation of the protection circuit in power supplies with overload protection circuits
(primarily in devices with no emergency power supply and output current of < 1.5 A).
 The specified temperature range applies only to use in deep-freeze warehouses. The manufacturer must be
consulted if deployment is to be in the condensation range.
30 / 31 ASD 535, Application guidelines for deep-freeze warehouses, T 131 390 c en
12 VDC operation 24 VDC operation
10.5 VDC 
approx. 575
approx. 660
approx. 645
approx. 745
approx. 575
approx. 695
approx. 645
approx. 820
approx. 15
approx. 30
approx. 20
approx. 25
approx. 20
grey 280 70 05 / anthracite violet 300 20 05
Notice
ASD 535
10.5 to 30
18 VDC 
approx. 340 approx. 260
approx. 390 approx. 295
approx. 380 approx. 290
approx. 450 approx. 350
approx. 340 approx. 260
approx. 405 approx. 310
approx. 380 approx. 290
approx. 490 approx. 385
approx. 10 approx. 7
approx. 20 approx. 14
approx. 10 approx. 5
approx. 15 approx. 10
approx. 10 approx. 5
max. 100
approx. 5
for max. 1
Ø 20 / 25
Ø 3 / 3.5 / 4 / 4.5 / 5
EN 54-20, class A, B, C
3K5 / 3Z1
–30 – 0 
–30 – 0 
–30 – +70
Ø 5 – 12 (M20) / Ø 9 – 18 (M25)
ABS blend, UL 94-V0
EN 54-20
265 x 397 x 148
max. 3,850
VDC
Typical
24 VDC
mA
mA
mA
mA
mA
mA
mA
mA
mA
mA
mA
mA
mA
mA
110 mA
A
ms
see Sec. 3.5
Mm
see Sec. 3.5
mm
54 IP
class
°C
°C
20 
°C
°C
must be identical
95 % rel. hum.
70 % rel. hum.
50 VDC
1 A
30 W
100 mA
2.5 mm²
mm
43 dB (A)
RAL
mm
g