Siemens SINAMICS G120 Operating Instructions Manual page 219

Unassigned interconnection and length
Table 6-24
Abbreviation
PZD
STW
ZSW
NSOLL_A
NIST_A
NIST_A_GLATT
IAIST_GLATT
Interconnection of the process data
Figure 6-13
In the inverter, the send data are available in the "Word" format (p2051) - and in the "Double
word" format (p2061). If you set a specific telegram, or you change the telegram, then the
inverter automatically interconnects parameters p2051 and p2061 with the appropriate signals.
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE
Explanation of the abbreviations
Explanation
Process data
Control word
Status word
Speed setpoint
Speed actual value
Smoothed actual speed val‐
ue
Smoothed current actual val‐
ue
Interconnection of the send data
Advanced commissioning
6.5 Drive control via PROFIBUS or PROFINET
Abbreviation Explanation
PKW Parameter channel
MIST_GLATT Actual smoothed torque
PIST_GLATT Actual smoothed active power
M_LIM Torque limit value
FAULT_CODE Fault code
WARN_CODE Alarm code
MELD_NAMUR Message according to the VIK-NA‐
MUR definition
219