Perform Failover; Remote Management Command - GE MDS Master Station Technical Manual

Timeout – The time (in milliseconds) that will result in a timeout if no response is
•
received within that period.

Perform Failover

If the Master Station is equipped with redundant SD radios, the active radio can be manually
toggled by selecting the "Perform" action.
The manual toggle-switch on the alarm/relay board must be in the 'Automatic' position
for this operation to succeed. The toggle-switch will override all software-based control
of which radio is active.

Remote Management Command

The Master Station has the ability to broadcast management commands to remote SD radios in
the network. These commands are sent to all connected remote radios, and hence should only be
used for making network-wide changes.
The following action can be specified:
Reboot – All remote radios will reboot to the currently active firmware image.
•
Set Radio Mode – Change the radio mode of remote radios
•
(x710/transparent/packet/packet-with-MAC)
Set Frequencies – Set the receive and transmit frequencies of remote radios.
•
Set Modem Type – Change the configured modem of remote radios.
•
Set Transmit Tolerance – Change the configured transmit tolerance of remote radios.
•
Set System ID – Change the configured system ID of the remote radios.
•
Enable Bridge – Enable or disable Ethernet bridging on remote radios.
•
Enable Encryption – Enable or disable OTA encryption on remote radios.
•
66 MDS™ Master Station MDS 05-6399A01, Rev. E