– giri/min
– kierr/min
– r/min
– omdr/min
– v/min
– o/min
Buzzer
If "Yes" is programmed, the buzzer is activated along with program
stop signal 1 and 2, the block end signal and the fault stop signal.
The buzzer frequency increases with the fault stop signal. The buzzer
switches off if a button is pressed, and automatically after 5 minutes.
If "No" is programmed, the buzzer is not activated.
Options:
– No
– Yes
Maximum temperature
This value can be set from cold to 203°F (95°C) in 1° increments and
limits all temperature settings in the programs to the selected value.
This means that when 140°F (60°C) is selected, for example, the wa-
ter will not be heated to more than 140°F (60°C) in any program even
if a higher temperature is programmed for the selected program.
Options:
– Cold
– 59 to 203°F (15 to 95°C)
Display standby
With the setting "Display standby: Yes", the display is switched on
when one of the controls is operated. If there are no further opera-
tions, the display switches to standby after 10 minutes. The start
button light ring flashes to let you know this has happened. The dis-
play is switched on again by operating any control; the last screen
active then appears.
When "Display standby: No" is set, the display is permanently on.
Choose from the following options:
– Yes
– No
Settings option
93