GE T60 Instruction Manual page 779

APPENDIX H
Table H–3: MAJOR UPDATES FOR T60 MANUAL REVISION AA3 (Sheet 2 of 2)
PAGE PAGE CHANGE
(AA2) (AA3)
5-159 5-159 Update
A- A- Update
B- B- Update
Table H–4: MAJOR UPDATES FOR T60 MANUAL REVISION AA2
PAGE PAGE CHANGE
(AA1) (AA2)
--- --- Update
--- --- Update
5-23 5-23 Add
5-31 5-31 Add
B-58 B-58 Delete
B- B- Update
H-8 H-8 Update
Table H–5: MAJOR UPDATES FOR T60 MANUAL REVISION AA1
PAGE PAGE CHANGE
(Z1) (AA1)
--- --- Add
--- --- Add
2- 2- Update
2-15 2-15 Delete
2- 2- Update
5-221 5-221 Update
6-21 6-21 Add
--- 6-25 Add
8- --- Delete
--- 9- Add
--- D- Add
Table H–6: MAJOR UPDATES FOR T60 MANUAL REVISION Z1 (Sheet 1 of 2)
PAGE PAGE CHANGE
(Y3) (Z1)
--- --- Add
--- --- Add
-- -- Add
GE Multilin
DESCRIPTION
Updated FlexLogic operands table
Updated FlexAnalog and FlexInteger tables
Updated Modbus memory map and F codes
DESCRIPTION
General revision throughout document
Updated references to digital inputs/outputs to contact inputs/outputs for consistency
Added Syslog Format section
Added Far-End Fault Indication (FEFI) section
Deleted Permissive Overreach Transfer Trip (POTT) Settings from Modbus memory map table
(registers A070 through A07E)
Updated Modbus memory map and F codes
Updated product warranty from 24 months to 10 years
DESCRIPTION
Added frequency rate of change function to chapter 2 Specifications, chapter 5 Settings, chapter
6 Actual Values, Appendix A table, and Appendix B tables, as per F60 implementation
Added content for IEC 60870-5-103 throughout document
Updated order codes
Deleted software options 20, 21, 22, and 23 from process bus order code tables as per exception
30009
Updated specifications
Updated Neutral Directional Overcurrent settings to include Dual-V and Dual-I settings to reflect
enhanced polarity criteria
Added Z to Table 6-2 FlexElements Base Units
BASE
Added Distance section for Actual Values > Metering > Distance
Deleted chapter 8 on security, moving content to other chapters
Added Maintenance chapter, moving content from other chapters and adding new instructions to
replace the battery
Added new appendix on IEC 60870-5-103 interoperability
DESCRIPTION
Added CPU options U and V to order code tables in chapter 2, a note above Rear Terminal View
figure in chapter 3, and CPU Module Communications Wiring figure in chapter 3
Added Parallel Redundancy Protocol (PRP) to order code tables and specifications in chapter 2,
section 5.2.5d Settings > Product Setup > Communications > Network, section 6.3.1 Actual
Values > Status > PRP, and Appendix B Modbus table and F627 and F628 enumeration tables
Added CT failure feature to Table 2-2 Other Device Functions, to chapter 5 Settings > Control
Elements > Monitoring Elements > CT Failure Detector, and Appendix B table F124 List of
Elements as bitmask element 246 CT Failure
T60 Transformer Protection System
H.1 CHANGE NOTES
H
H-3