Cleaning And Maintenance; Cleaning My Nokia Steel Hr; Charging The Battery; Replacing The Wristband - Nokia Steel HR Installation And Operating Instructions Manual

Cleaning and Maintenance

Cleaning my Nokia Steel HR™

1. Use a lint-free cloth moistened with water to clean the glass and casing
of your Nokia Steel HR™.
2. Run the silicone band under water and rub it with hypoallergenic soap to clean it.
3. Dry the silicone wristband with a soft cloth.

Charging the battery

Your Nokia Steel HR™ can operate for up to 25 days on a single charge, depending
on your use of the heart rate mode. Using the continuous heart rate mode all the time
instead of just during activities will deplete the battery much faster.
To charge your Nokia Steel HR™, perform the following steps:
1. Connect the USB end of the charging cable to a power source .
2. Position the other end of the charging cable on the back of your Nokia Steel HR™
in such a way that the magnets align.
You can check the percentage of the battery on the display of the watch while
it's charging.
Note that if you don't charge your Nokia Steel HR™ right away, the power reserve mode
will allow you to keep using it for 20 additional days. However, you will only be able to read
the time and track your activity in this mode. You will need to charge your Nokia Steel HR™
to use the heart rate mode.

Replacing the Wristband

You can easily replace the wristband of your Nokia Steel HR™ thanks to the quick release
spring bars with which it is attached. The 36-mm model requires wristbands that are 18-
mm wide, while the 40-mm model requires wristbands that are 20-mm wide.
To change the wristband, perform the following steps:
1. Turn your Nokia Steel HR™ over.
2. Locate the knob of each spring bar.
3. Pull the knob of the first spring bar to the left side and remove the wristband.
Nokia Steel HR™
v3.0 | May, 2017
EN - 39