HP A6602 Installation Manual page 87

Figure 6-6 Structure of a blank panel
(1) Front view of a blank panel (1) Front view of a blank panel
(3) Back view of a blank panel (3) Back view of a blank panel
Removing a Blank Panel Removing a Blank Panel
Follow these steps to remove a blank panel: Follow these steps to remove a blank panel:
Step1 Position the router so that the rear panel of the router faces you. Position the router so that the rear panel of the router faces you.
Step2 Select the slot where you will install a HIM or MIM. Select the slot where you will install a HIM or MIM.
In the case that you need to install a HIM, remove both the upper and lower blank panels in In the case that you need to install a HIM, remove both the upper and lower blank panels in In the case that you need to install a HIM, remove both the upper and lower blank panels in

Slot 1 or Slot 2.
In the case that you need to install a MIM, remove the lower blank panel in Slot 1 or Slot 2. In the case that you need to install a MIM, remove the lower blank panel in Slot 1 or Slot 2. In the case that you need to install a MIM, remove the lower blank panel in Slot 1 or Slot 2.

Step3 Remove the fastening screws on the blank panel with a Philips screwdriver.
Figure 6-7 Remove a blank panel
Place the removed blank panel(s) and screws in a safe place for later use. Place the removed blank panel(s) and screws in a safe place for later use.
Installing a Blank Panel Installing a Blank Panel
After a HIM or MIM is removed from the router, you are r After a HIM or MIM is removed from the router, you are recommended to install one or two
blank panels to prevent dust from entering the chassis if you do not install any interface module blank panels to prevent dust from entering the chassis if you do not install any interface module blank panels to prevent dust from entering the chassis if you do not install any interface module
in the slot.
Follow these steps to install a blank panel: Follow these steps to install a blank panel:
Step1 Position the router so that the rear panel of the route Position the router so that the rear panel of the router faces you.
Step2 Remove the HIM or MIM from a slot. For the removal procedure, refer to Remove the HIM or MIM from a slot. For the removal procedure, refer to "
page 6-7 or "Removing a MIM Removing a
Step3 Install one or two blank panels in the slot. Install one or two blank panels in the slot.
Structure of a blank panel
ing screws on the blank panel with a Philips screwdriver.
Remove a blank panel
MIM" on page 6-8.
(2) Side view of a blank panel (2) Side view of a blank panel
(4) EMI gasket
ecommended to install one or two
"Removing a HIM Removing a HIM" on