HP A6602 Installation Manual page 41

Figure 3-17 Connect the console cable
(1) Console port
(3) Serial port on the configuration terminal
(5) RJ-45 connector
When connecting a PC to the router with the console cable, first connect the DB-9 connector to
the serial port on the PC, and then the RJ-45 connector to the console port on the router.
Connecting the AUX Port to a Modem
The AUX port is usually used for remote configuration or dial backup. In this case, you need to
connect the local modem to the remote modem through PSTN and then to the remote device.
Follow these steps to connect the AUX port with an AUX cable.
Step1 Plug the RJ-45 connector of an AUX cable into the AUX port on the router.
Step2 Plug the DB-25 (male) or DB-9 (male) connector into the serial port on the
analog modem.
(2) DB-9 (female) connector
(4) Console cable