Conductivity; Control Panel Switch-Off Status - Miele TCE 630 WP Operating Instructions Manual

Programmable functions
 Conductivity

This programmable function
should only be altered if the water is
so soft that it is likely to cause the
electronics which sense residual
moisture in the laundry to give false
readings.
Options
 = Off (factory default)
 = Low
Important
This programmable function should only
be set if the water used for washing the
laundry is extremely soft with a
conductivity reading (electrical
conductivity) of less than 150 μS/cm.
Contact your local water authority for
the conductivity level of your mains
water supply.

Make sure that you only activate
 for the condition described
above.
Otherwise drying results can be
unsatisfactory.
68
 Control panel switch-off
status
To save energy the time display and
sensors will go out after 10 minutes,
and only the Start/Stop sensor will
flash slowly. You can change this
automatic switch-off function.
However, there is no switch-off in the
event of a fault.
Options
 = Off
The time display and sensors
will remain lit up while the dryer
is switched on.
 = On (factory default)
The time display and sensors
will go out after 10 minutes . .
. . if no further selection is
made after switching the dryer
on.
. . after a programme has
started.
However, the time display and
sensors will remain lit up for 10
minutes after a Delay start time
has elapsed, after the end of a
programme, or at the end of
the Anti-crease phase.
"Switch on" display again
– Turn the programme selector to any
position (other than ) or touch a
sensor. This will not alter a running
programme.
– Open the door while the dryer is
switched on.