ABB 9438 User Manual page 22

...7 PROGRAMMING AND ELECTRICAL CALIBRATION
...7.4 Set Up Alarm Page
...Continued from A1 Action
1 5 0 .
High Spt ug/kg
5 0 .
Low Spt ug/kg
0 0 0 0 0
Alter Sec. Code
0 0 0 0 0
Alter Cal. Code
– – – – –
SET UP RETRANS
20
High Set Point
The set point can be set to any value within the full measurement range, with the
High
units automatically changing.
The set point value is subject to hysteresis as detailed above.
Set the alarm set point to the required value.
Displayed only if
Alarm Action
Low Set Point
The set point can be set to any value within the full measurement range, with the
Low
units automatically changing.
The set point value is subject to hysteresis as detailed above.
Set the alarm set point to the required value.
Displayed only if
Alarm Action
Alter Secure Parameters Security Code
Set the secure parameters security code to a value between 00000 and 19999.
IMPORTANT – YOU MUST MEMORIZE THE NEWLY SET SECURITY CODE. If it is
forgotten contact the Company for advice.
Alter D.O. Sensor Calibration Security Code
Set the pH calibration security code to a value between 00000 and 19999.
IMPORTANT – YOU MUST MEMORIZE THE NEWLY SET SECURITY CODE. If it is
forgotten contact the Company for advice.
Advance to
Set Up Retransmission Page
is set to or .
High Hi/Lo
is set to or .
High Hi/Lo
, Section 7.5.