Export Data; Manual Bind; Set Password - YUNEEC H520 Owner's Manual

E D
XPORT ATA
Export Data transfers all the saved missions and telemetry logs from the ST16S to the microSD Card. This
feature is for sharing data between ST16S or for debugging issues. These exported data files will be useful
in the event of an incident, allowing Yuneec technical support to determine cause of incident.
M B
ANUAL IND
Manual bind allows the Pilot to bind the ST16S to the H520 without a camera. Power on the H520, tap the
Manual Bind button, and flip the H520 upside down. The H520 LEDs will begin flashing yellow on all motors.
Now tap the Bind button on the popup window. The ST16S will bind to the H520. This connection may be
tested by raising the landing gear while the H520 is upside down.
*Note: The H520 does not provide telemetry data to the ST16S while in manual bind mode. The Pilot will
not have the ability to check GPS status, battery status, etc.
S P
ET ASSWORD
Set Password empowers the Pilot or an IT department to change the connection password to the aircraft
and camera. Tap the Set Password soft button to open the password change dialog screen. Enter the new
password (8-20 characters) then re-enter it in the next box to confirm. Tap "Ok" to set the new password.
The aircraft must be restarted and reconnected using the new password.
Important Note: It is highly recommended that the aircraft always be re-
calibrated after each software/firmware update. This is a
safety practice to ensure the aircraft is always properly
calibrated.
46
Yuneec Electric Aviation
H520 Start Guide