Mode Select - Heatmiser edge Manual

Mode Select

Section Header
Edge can either be used as a thermostat or a time clock. Thermostat mode
is the default setting.
To change between thermostat & time clock modes, follow these steps.
• Use the 'Left/Right' arrow keys to highlight
button for 3 seconds ..................................................................................................
At this point the screen will go blank showing only 'SETUP' and 'CLOCK' .
Tap either of the 'Up' or 'Down' arrow keys to highlight 'SETUP' , then hold
•
the key for 10 seconds ................................................................................................
The edge will factory reset then provide 2 selectable mode options.
• Use the Left / Right keys to scroll between modes ...............................................
Mode 1 = Thermostat
Mode 2 = Time Clock
Note: the selected option will flash.
• Press the
The edge will reset all parameters and restart in the selected mode.
Note: The Mode Select function will reset all parameters (Wireless Air Sensors
and Window/Door Contacts excluded) that were entered during the set-up
operations. These processes must be repeated after the restart has completed.
7
key to confirm selection ........................................................................
then press and hold the