Advertisement
Selecting Multiple Gestations
Press CALIPER key.
1
Roll TRACKBALL to top of Measurement menu to highlight B, C or D (default is singleton-A).
2
In prompt box answer YES to multiple gestations question.
3
Use TRACKBALL to select YES, press SET key.
4
Measuring the Heart Rate with M- Mode
Press M-Mode key and obtain M-Mode cursor.
1
Position cursor, press M-Mode key again for tracing.
2
Obtain sweep, press FREEZE key.
3
Press Caliper key.
4
Select HR (heart rate) from SOFT KEY menu.
5
Roll TRACKBALL to place measurement marker at the beginning of the cardiac cycle, press SET key.
6
Roll TRACKBALL to place second measurement marker at the end of the first cardiac cycle, press SET key. Heart rate will
7
be displayed on screen and transferred to Worksheet
Editing Measurements in the Worksheet
Rotate SELECT control to highlight Worksheet in the control Menu, press SELECT control.
1
Roll TRACKBALL to the value to be deleted/edited, press SET key.
2
Use the keyboard to delete or edit value.
3
Press ENTER, system updates the value.
4
Measure AFI using 4B
Rotate the SELECT control to highlight 4B in the control menu, press SELECT control.
1
Obtain first quadrant image, press Freeze.
2
Repeat process until 4 quadrant images have been obtained.
3
Press CALIPER key.
4
Rotate SELECT control to highlight Page, press to select page 2/3.
5
Rotate SELECT control to highlight AFI menu, press SELECT control.
6
Place first measurement marker, press SET key.
7
Place second measurement marker, press SET key.
8
Repeat this process in each quadrant.
9
Press 2D control to exit 4B.
10
Note: AFI will be displayed on screen and transferred to Worksheet.
DIMAQ: Reviewing and Selecting Images/Studies
To review images stored during an active exam
Press Patient Browser key on the control panel.
1
Active patient images stored will be displayed.
2
Advertisement
