Whirlpool Vessi Use And Care Manual page 27

CLEANING AND SANITIZING YOUR VESSI™
FERMENTOR & DISPENSER
Gently replace the top stainless
steel end cap� Make sure the
gasket is properly seated into the
9
grooves in the top stainless steel
end cap� There should be a slight
gap between the top and bottom
stainless steel end caps�
1
3
Using the supplied hex wrench,
partially install the 2 top screws,
10
then the 2 bottom screws� Fully
tighten all 4 screws� The gap
should now be closed�
CLEANING AND SANITIZING YOUR VESSI™ FERMENTOR & DISPENSER | 27
Gap
11
Tri-clamp
2
12
4
Remove the 2" stainless steel cap
from the bottom on the vessel�
Align the gasket and the SRS with
the 2" opening at the bottom of
the vessel�
Attach the SRS with the tri-clamp
and hand-tighten�
Slide the purge tank onto the
13
bottom of the SRS� Ensure that
the purge tank is fully engaged�
Gasket