Dtc C1015 (No. 15): G Sensor Circuit - Suzuki Liana RH413 Service Manual

Step
9 1) Turn ignition switch to OFF position.
2) Check proper connection at "E15-5" ("BLU" wire)
terminal for serial data circuit.
3) If OK, then check resistance between "E15-5" ("BLU"
wire) terminal and "BLU" wire terminal (2) for serial data
circuit in DLC (1).
Ω
Is resistance 1 or less?

DTC C1015 (No. 15): G Sensor Circuit

DTC Detecting Condition
If the signal voltage of G sensor while at a stop does not vary from that while running, this DTC is set.
Therefore, this DTC may be set when a vehicle is lifted up and its wheel(s) is turned. In such case, clear the DTC and
check again.
DTC Troubleshooting
1) Ignition switch OFF.
2) Check for proper installation of ABS hydraulic unit / control module assembly.
3) If OK, substitute an ABS hydraulic unit / control module assembly with correct part number.
4) Recheck system.
Action
I3RH0A450016-01
Yes
Substitute a known-
good ABS hydraulic unit
/ control module and
recheck.
ABS: 4E-23
No
Repair high resistance
or open in "BLU" wire
circuit for anti lock brake
system.
S3RH0A4504014