Grooving Residual Material (Cycle952) - Siemens SINUMERIK 840D Operating Manual

Programming technological functions (cycles)
8.5 Contour turning - only for G code programs
Parameters Description
ZD - (only for unmachined part description, cylinder and allowance)


Allowance Allowance for pre-finishing - (only for ∇∇∇)


U1 Compensation allowance in X and Z direction (inc) – (only for allowance)


Set machining area Set machining area limits
limits


N Number of grooves
DP Distance between grooves (inc)
8.5.10

Grooving residual material (CYCLE952)

Function
The "Grooving residual material" function is used when you want to machine the material
that remained after grooving along the contour.
For a G code program, first select the "Grooving residual material" function. Material that
remains as part of the finishing allowance is not residual material. The "Grooving residual
material" function allows you to remove unwanted material with a suitable tool.
The "Grooving residual material" function is a software option.
398
For unmachined part description, cylinder
Allowance or cylinder dimension (abs or inc)
For unmachined part description, allowance
Allowance on the contour (abs or inc)
Yes
U1 contour allowance
No
Positive value: Compensation allowance is kept
Negative value: Compensation allowance is removed in addition to finishing
allowance
Yes
– XA: 1. Limit XA ∅
– XB: 2nd limit XB ∅ (abs) or 2nd limit referred to XA (inc)
– ZA: 1. Limit ZA
– ZB: 2nd limit ZB (abs) or 2nd limit referred to ZA
No
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
Unit
mm
mm
mm
mm
Milling