Figure 3.25 Mounting An Interface Module In A Slot; Figure 3.26 Locking The Front Panel Lever Of The Interface Module - Samsung OfficeServ 7400 Installation Manual

Hide thumbs Also See for OfficeServ 7400:

Table of Contents

The procedure for mounting an interface module in a slot is as follows:

1) Check the interface module for any damage. If any is evident, do not continue with the

installation and contact your dealer.

2) Align the module with the guardrail of the slot of the basic or expansion chassis, and

slide the module into the slot.

3) Push the front panel lever of the module until the module is completely inserted into

the connector on the OfficeServ 7400 main board.

Figure 3.25 Mounting an Interface Module in a Slot

OfficeServ 7400 Installation Guide

3-21

Table of Contents