Access To Eh-Eth2 Configurator - Hitachi EH-150 Applications Manual

5.2.5

Access to EH-ETH2 Configurator

When PLC is power on, STS LED turns on or blinks. You can access EH-ETH2 Configurator at both
conditions. We recommend setup the I/O assignment on CPU at first.
In the case that it is done with I/O correctly
In the case that it is not done with I/O assignment
Caution
- You can access EH-ETH2 Configurator without I/O assignment, but you can not use on-line connection of LADDER
EDITOR for Windows or Control Editor via Ethernet, and ASR connection data transmission without I/O assignment.
Open the "Communication Setting" window from [Option] menu in the initial screen (Figure 5.5), set
destination IP address to connect to EH-ETH2.
For instance, in the case of the temporary IP address is "192.168.0.1", input "192.168.0.1" into IP address
field (Figure 5.6). Port No. is fixed to "65535".
Figure 5.5
Chapter 5 Configuration of Communication parameters
POW STS WDE
TX1 RX1 TSK
TX2 RX2 OP1
OP3 OP4 OP5
ETHERNET EH-ETH2
Figure 5.4 STS LED condition
The initial screen of EH-ETH2 Configurator
Figure 5.6 Communication Setting window
5-6
ERR
IER
OP2
OP6
illumination
blinking 0.25s