Configuration Of The Activation Keys - Panasonic KX-NS1000 Installation Manual

5.4.5 Configuration of the Activation Keys

5.
The activation keys will be copied to the Master unit, and then the activation keys that Slave units require
will be copied to the Slave units of the One-look network. When installation is complete, the message,
"The activation key has been installed and activated successfully!" is displayed.
6.
Click OK.
Notice
The activation key file can only be installed in the PBX with the MPR ID number entered when the activation
key file was downloaded. The activation key file cannot be reissued unless the mother board crashes.
Note
•
You can click the provided link to directly access activation key information and program the number
of activated IP CO lines and IP softphones.
•
For information about programming activation keys using Web Maintenance Console, refer to "9.3 PBX
Configuration—[1-1] Configuration—Slot—Activation Key Status" in the PC Programming Manual.
5.4.5 Configuration of the Activation Keys
Depending on your configuration, it may be necessary to program the number of provided IP CO line channels
to be used for H.323 CO lines. By default, all of the provided IP CO line channels will be used for SIP CO lines.
Similarly, you can program how many IP softphone(s) can be used through the IP Softphone/IP Proprietary
Telephone/P-SIP Extension activation key. By default, only IP softphone(s) can be used through the IP
Softphone/IP Proprietary Telephone/P-SIP Extension activation key.
204 Installation Manual
1. a. Click Setup ® PBX Configuration ®
Configuration ® Slot.
b.
Click Activation Key.
a.
2.
In Number of activated IP-GW, type the number of
IP CO line channels to be used for H.323 CO lines.
Note
If you have changed the value for Number of
activated IP-GW, you must click Execute to
restart the V-IPGW16 cards for the change to
take effect.
b.
In Number of activated IP-Softphone, type the
number of IP softphones to be used through the IP
Softphone/IP Proprietary Telephone activation key.
3. Click OK.
Document Version 2016-03