Chapter 3 Cpu Module Start-Up Procedures - Mitsubishi Electric Q26UD(E)HCPU User Manual

CHAPTER 3
This chapter provide the start-up procedure for the Q Series CPU module on the assumption that programs and
parameters have been created separately.
For the start-up procedures for a redundant system configured with a Redundant CPU, refer to the following.
QnPRHCPU User's Manual (Redundant System)
Module installation
Install any of the following modules required for the system configuration to the
base unit.
• Power supply module
• CPU module (Install a memory card, SD memory card, or extended SRAM
cassette as needed.)
• Intelligent function module and/or special function module
• Network module
• I/O module
Wiring/connection
1) Wire the power supply to the power supply module.
2) Wire external device(s) to intelligent function module(s), special function
module(s), and/or I/O module(s).
3) Install wiring between network modules.
4) Install the battery to the CPU module.
5) Connect the main base unit to an extension base unit and also between
extension base units by extension cables and then set the number of bases
to extension base units.
Module initial settings
1) Halt the CPU module.
2) Set up switches of the intelligent function module(s) and/or special function
module(s).
3) Set up switches of the network module.
System power on
Confirm the following items of the system, and then power on the system.
• Wiring of the power supply
• Power supply voltage
• Operating status of the CPU module: Stop status (reset canceled)
Connection of the PC in which a programming tool is installed
1) Start up Programming tool on the personal computer in which the
programming tool is installed.
2) Connect the personal computer in which the programming tool is installed,
to the CPU module.
CPU MODULE START-UP
PROCEDURES
Start
(To next page)

CHAPTER 3 CPU MODULE START-UP PROCEDURES

Page 59, CHAPTER 4
• • •
Page 59, CHAPTER 4,
• • •
Page 243, CHAPTER 10,
Page 246, CHAPTER 11
Page 119, CHAPTER 6
• • •
Page 119, CHAPTER 6,
• • •
Page 187, CHAPTER 7,
Page 59, CHAPTER 4
Operating manual for the
• • •
programming tool used
3
57