D400 applications
Applications available with D400 redundant operation
116
This section lists the configurable applications that may be available for your D400. The
applications available to you depend on your D400 firmware version and configuration.
You set up and run the applications using a variety of tools and utilities that are provided
with the D400.
Table 27 lists the D400 applications that are available with the:
•
Warm Standby redundancy mode
•
Hot Standby redundancy mode.
Not all protocols are supported in the Hot Standby Redundancy mode.
Carefully review product documentation and configure Redundancy accordingly.
Table 27: Redundant D400 operation - available applications
Application Name
Client Application (DCA)
DNP3
Generic ASCII
IEC® 60870-5-101+104
IEC 60870-5-103
IEC 61850
Hydran®
SEL Binary
MODBUS®
D.20 Network Client
SNMP
Server Application (DPA)
IEC 60870-5-101+104
DNP3
MODBUS®
Automation Application (DTA)
Alarm
Calculator
Data Logger
System Point Manager
LogicLinx®
ARRM (Automated Record Retrieval Manager)
Load Shed and Curtailment
Analog Reports
Tools/Utilities
Runtime HMI
Online Configuration Tool
Offline Configuration Tool
GE INFORMATION
CHAPTER 9: ABOUT THE D400 APPLICATIONS
Redundancy Mode
Warm Standby
Hot Standby
Not Available
Not Available
Not Available
Not Available
Not Available
Not Available
Not Available
Not Available
Not Available
Not Available
Not Available
Not Available
D400 SUBSTATION GATEWAY INSTRUCTION MANUAL
License
required
Yes
Yes
Yes