DeWalt DCT412 Original Instructions Manual page 42

EN GLI SH
q. Forward Arrow: Press this button to
navigate forward.
r. Power indicator for the handle set:
When the green light is on it indicates
that the handle set is on.
s. Reset button
INTENDED USE
The inspection camera is designed to play real-time
video while looking into walls and/or tight spaces.
With a micro SD card (sold separately), the tool can
then take photos or record videos for documentation
purposes.
Photos are saved in JPG format and videos are
saved as AVI. This D WALT inspection camera is
E
compatible with micro SD memory cards up to
16 gigabytes.
Applications consist of automotive inspection,
plumbing inspection, HVAC inspection or cable
routing. Read the entire manual before using this
inspection camera.
DO NOT use in presence of flammable liquids or
gases. The camera cable extension is waterproof up
to the camera connector. DO NOT USE the handle
set under wet conditions or submerge in liquid.
The inspection camera is a professional tool.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities, or for lack
of experience and/or for want of knowledge or
skills unless they are supervised by a person
responsible for their safety. Children should
never be left alone to play with this product.
Electrical Safety
The charger has been designed for one voltage
only. Always check that the battery pack voltage
corresponds to the voltage on the rating plate.
Also make sure that the voltage of your charger
corresponds to that of your mains.
Your D WALT charger is double insulated
E
in accordance with EN 60335; therefore
no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E
40
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see Technical data). The minimum conductor size
is 1 mm 2 ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: Prior to assembly and
adjustment, always remove the battery
pack. Always turn the inspection camera
off before inserting or removing the
battery pack.
WARNING: Use only D
packs and chargers.
Screen (fi g. 4)
When the screen is attached to the handle set with
a battery, it will receive a charge from the battery.
Ensure the screen is fully charged before use.
When the screen is disengaged from the handle set,
a battery icon appears in the upper left corner. This
icon also displays the current charge of the screen.
To install the screen (e) into the handle set (g), align
the screen with the rails on the handle set and slide
it firmly into the handle until you hear the lock snap
into place.
To remove the screen from the handle set, firmly
slide the screen up from the tool handle.
The screen can be turned on and viewed when it
is not attached to the handle set, allowing easier
maneuverability of the camera.
WALT battery
E