ABB ACS550-01 User Manual page 39

ACS550-01/U1 User's Manual
After completing a set-up task, the Start-up Assistant suggests the
next one.
• Press OK
suggested task.
• Press key
the following task without doing the suggested task.
EXIT
• Press
The start-up is now completed. However, it might be useful at this
stage to set the parameters required by your application and save
the settings as a user parameter set as instructed in section
parameter sets
After the whole set-up is completed, check there are no faults or
alarms shown on the display and the panel LED is green and does
not blink.
(when is highlighted) to continue with the
Continue
to highlight
Skip
to stop the Start-up Assistant.
SAVING A USER PARAMETER SET AND FINAL CHECK
on page 83.
The drive is now ready for use.
and then press OK
REM
CHOICE
Do you want to
continue with
application setup?
Continue
Skip
EXIT
to move to
User
Start-up, control with I/O and ID Run
39
00:00 OK