Removing The Transportation Damper - Epson TM-U295 Installation Manual

English
Indicators (LEDs)
POWER
This LED is on whenever power is supplied to the printer.
RELEASE
This LED is on when the printer is in the paper release mode and it
is off when the printer is in the clamp mode. Paper can be inserted
only when the printer is in the paper release mode.
This LED flashes to indicate an error condition in the following
cases:
❏ Paper jam
❏ Home position error
❏ Timing error
❏ Drive circuit error
❏ Power supply voltage error
If this LED flashes, turn off the printer, make sure that no paper is
jammed in it, and then turn it back on. If the LED is still flashing,
contact your administrator or a qualified service person.
PAPER OUT
This LED is on when paper is not inserted or is not inserted
correctly.

Removing the Transportation Damper

The printer is protected during shipping by a transportation
damper that must be removed before you turn on the printer.
Pull the damper out and remove the strip of tape from the top of the
printer, as shown below.
6 TM-U295 Installation Manual