For safety and correct product connection, always install the product as shown in the wiring diagram below:
4 Monitors + 1 Door camera + 1 Multi panel
Be sure the multi panel connect to the DOOR2 port.
The door lock can connect to the doorphone. If the door lock is connected, be sure set the DOOR OPEN SET
item of the supervisor setting mode is CAMERA for door open function.
Installing the door lock system designated by our company to your entrance door enables you to open the door by
pressing the Door Open button during an entrance call.
1 Monitor + 1 Doorbell + 1 Door lock
If a doorbell is connected, the DOOR1 port does not connect anything.
If a doorbell is connected, be sure set the BELL SET item of the supervisor setting mode is SET.
24
Connection cable specifications
Monitor VS Door Camera
1 [RED]
+ 12 V
2 [GREEN]
VOICE
3 [WHITE]
VIDEO
4 [BLACK]
GND
Monitor VS Door Lock
1 [RED]
DOOR LOCK
2 [BLACK]
Monitor VS Bell
1 [RED]
Door Bell
2 [BLACK]
Do not connect to AC Power. It may result in electrical shock and/or fire.
Various settings
Setting supervise mode
[Setting J1 Jumper on the SVD-4332' s bottom]
Normal mode
(Insert)
(Remove)
Refer to 11 page
for only supervise
settings
After changing the setting switch, always turn the power off and on.
Monitor VS Multi Panel
1 [RED]
+ 12 V
2 [GREEN]
VOICE
3 [WHITE]
VIDEO
4 [BLACK]
GND
Monitor VS Slave
1 [RED]
+ 12 V
2 [BLUE]
DATA
3 [ORANGE]
SOUND 1
4 [VIOLET]
SOUND 2
5 [WHITE]
VIDEO
6 [BLACK]
GND
25