Hitachi IJ RX2 Service Manual page 152

6 Remove the removed tube from the fixing clamp.
7 Perform "4.1.3 Approach to the parts on the rear side of the equipment"
and open the unit door.
8 Remove the back cover.
Fastening screws
Fastening screws
screws
9 Rotate the Head H Clamp assembly by 45 degrees and pull the Head H Clamp
Assembly out.
10 Widen the Claws of Head H Clamp assembly and remove it from the harness of
the print head.
Head H Clamp assembly
assembly
[Note] Follow the reverse orders as shown in the figures above when you mount the cable.
Fastening screws
Head H Clamp assembly
assembly
FG line(Green)
High voltage line
(White)
Excitation line(Black)
Claws
Cable Signal： №5
Fastening screws (11 locations)
Video signal line(Black)
Cable Signal： №3
4-28
Fastening screws
14-core cable(Black)
cable(Black)
[the thickest cable]
APH line(Black)
Cable Signal： №2