Canon imageRUNNER 1750 Copying Manual page 34

● If you want to select a nonstandard paper size:
IMPORTANT
• An underbar (_) must be entered between integer and fraction.
• The following modes are not available for nonstandard size paper: Offset +
Collate, Offset + Group, Staple, 1 to 2-Sided, 2 to 2-Sided, Image Combination,
or ID Card Copy.
NOTE
• If you make a mistake when entering values, press [C] (Clear) ➞ enter the
correct values.
• To enter values in millimeters, press [mm].
• When entering values in millimeters, you can also use
and (Clear) on the control panel.
• You can store up to two sets of frequently used sizes. Press [Store/Edit] ➞
[Size 1] or [Size 2] ➞ enter the value for <X> and <Y> ➞ press [OK].
• To recall the stored size, press [Size 1] or [Size 2] ➞ press [OK] and proceed to
the next step to specify the paper type.
❑
Press [Irreg. Size].
❑
Press [X] ➞ enter the length along the
horizontal axis of the paper using the
numeric keys.
The horizontal length can be set
between 5 9/16" and 24 3/4" (140 mm
and 630 mm).
❑
Press [Y] ➞ enter the length along the
vertical axis of the paper using the
numeric keys.
The vertical length can be set between
3 15/16" and 8 1/2" (99 mm and
216 mm).
❑
Press [OK].
-
Selecting the Paper Size
2
(numeric keys)
2-7