Utility-System Initialise/Restart - Panasonic KX-TVM50 Programming Manual

1.8 Utility
System Maintenance Start Time
Specifies the System Maintenance start time.
Value Range
HH:MM (HH: Hour, MM: Minute)
HDD Auto Stand-by Mode
Specifies whether to enable or disable HDD Auto Stand-by Mode.
Value Range
Disable, Enable
HDD Auto Stand-by Delay Time
Specifies the length of time that the VPS waits before activating HDD Auto Stand-by Mode. If the time
period expires without the access to HDD, the VPS will function HDD Auto Stand-by Mode.
Value Range
0 min–21 min, 30 min/60 min
1.8.7 Utility—System Initialise/Restart
The System Initialise/Restart is used to restart the VPS. There are 2 methods as follows:
a)
Initialise System: clears all voice data except the installed system guidance, and returns all
system parameters to their default settings. The System Administrator has to specify the
following parameters before initialising the system:
–
–
–
b)
Restart System: restarts the system. The VPS is not initialised.
Follow the steps below to initialise or restart the VPS:
1.
Click Utility in the menu bar.
2.
Select System Initialise/Restart.
Initialise System
1.
Select "Initialise System".
(You can click the icon in the tool bar instead of step 1 and 2.)
2.
Specify "Mailbox No. Length (2–5 digits)", "System Manager's Mailbox No." and "Message
Manager's Mailbox No."
3.
Click Next.
4.
If there are active ports, the System Administrator will be asked to either to continue or to
cancel.
Select OK to continue, or Cancel to close the ports.
5.
Click OK.
Restart System
30 Programming Manual
Mailbox No. Length
System Manager's Mailbox No.
Message Manager's Mailbox No.