Auto Attendant Card; Svmi-8 / Cadence Card (Voice Mail); Svmi-16 Card (Voice Mail); Mgi2 Card - Samsung OfficeServ500 Installation Manual

Hide thumbs Also See for OfficeServ500:
Table of Contents

Advertisement

4-12
Chapter 4
Installing Processor and Interface Cards

Auto Attendant Card

CAUTION: Do not insert the card with system power on. Switch the power OFF.
This card has no selectable options
including five AA cards into any universal card slots
both card ejectors on each card to ensure that it is fully inserted into the backplane connector.
There is no connector on the front of this card.

SVMi-8 / Cadence Card (Voice Mail)

Before installing this card
and the appropriate number of voice processing modules. Refer to your Voice Mail
documentation for details.
The SVMi-8 / SVMi-16 / Cadence card is installed in any universal slot of any cabinet. Only one
card can be installed in a system and it counts as eight stations of the power supply rating.
Check that the cabinet power switch (PWR) is in the OFF position. Next, position the card in the
grooves of the card guide and gently slide the card in until it makes contact with the connector.
Press gently but firmly on the top and bottom of the front edge of the card until the card sits in its
connector.
(To configure the card, refer to

SVMi-16 Card (Voice Mail)

Before installing this card
and the appropriate number of voice processing modules. Refer to your Voice Mail
documentation for details.
The card is installed in any universal slot of any cabinet. Only one card can be installed in a
system and it counts as eight stations of the power supply rating. Check that the cabinet power
switch (PWR) is in the OFF position. Next, position the card in the grooves of the card guide and
gently slide the card in until it makes contact with the connector. Press gently but firmly on the
top and bottom of the front edge of the card until the card sits in its connector.
(To configure the card, refer to

MGI2 Card

The MGI2 card
the Internet using IP telephones.
Up to five MGI2 cards can be installed in a single cabinet. Insert each card into any universal
card slot. Push firmly in the middle of both card ejectors to ensure the card is firmly seated into
the backplane connector.
(Figure
(Figure
4-20), it should be correctly configured with a hard disk drive
Chapter 12, "SVMi-8/16 and Cadence Voice Mail
(Figure
4-21), it should be correctly configured with a hard disk drive
Chapter 12, "SVMi-8/16 and Cadence Voice Mail
(Figure
4-22) supports the VoIP Gateway, which enables telephone calls through
4-19) but is under software control. Insert up to and
(Figure
4-2). Push firmly in the middle of
Setup".)
Setup".)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents