Three Cabinet Installation - Floor Mount - Samsung OfficeServ500 Installation Manual

1. Mount the legs or castors on the main cabinet that is to be the floor mounted (base) cabinet
2-2).
2. Prepare both of the cabinets by removing the side and front covers of both prior to installation to
avoid damaging the covers and to allow access to the interior. Remove the top cover from the base
cabinet and the bottom and rear panels from the upper cabinet.
3. Place the upper cabinet on top of the base cabinet ensuring that the upper cabinet locating bumps
are snug in the base cabinet locating dimples. Install the two provided screws in the dimples in the
front lower panel of the upper cabinet and the two provided screws in the dimples in the rear lower
panel of the upper cabinet.
4. Replace the rear panel on the upper cabinet.
5. Proceed with the installation of the power supply unit(s), grounding, power connections, control
cards, interface cards and optional equipment as described in the following chapters.
When a power supply is installed, verify that the power switch is in the proper voltage setting,
110V or 220V as required. (See

Three Cabinet Installation - Floor Mount

One cabinet is to act as the main key service unit (KSU), the others as expansion cabinets.
Check that each cabinet carton includes the following items:
OfficeServ500 cabinet
Top cover
Left and right side covers
Front cover
Cabinet leg mounting kit
AC power and DC power cables
Check that all additional hardware and software is available for installation.
Floor mounting equipment (legs or castors).
Cards required to make the system functional (i.e., power supply, central processor, station and
trunk cards)
1. Mount the legs or castors on the cabinet that is to be the floor mounted (base) cabinet
2. Prepare all of the cabinets by removing the side and front covers of each cabinet prior to installation
to avoid damaging the covers and to allow access to the interior. Remove the top cover from the
base and centre cabinets, and the base and rear panels from the centre and upper cabinets.
3. Place the centre cabinet on top of the base cabinet ensuring that the centre cabinet locating bumps
are snug in the base cabinet locating dimples. Install two of the provided screws in the dimples in
the front lower panel of the centre cabinet and the other two provided screws in the dimples in the
rear lower panel of the centre cabinet. Replace the rear panel of the centre cabinet.
Figure 3-3 in Chapter 3.)
2-3
(Figure
(Figure 2-2).