3. Lift the clip on the rear of the flex module. Then, slide the flex module cover to the rear of the flex
module to remove the cover.
Figure 39. Removing the flex module cover
4. If you are replacing an eSATA connector or IEEE 1394 connector, do the following:
a. Disconnect the eSATA connector or IEEE 1394 connector cable from the system board. See "Parts
on the system board" on page 7.
b. Press the two clips toward each other as shown to pull the eSATA connector or IEEE 1394 connector
out of the flex module.
Figure 40. Removing the eSATA connector or IEEE 1394 connector in the flex module
78
ThinkStation P510 and P710 User Guide