Id Mode; Preparations - Canon VC-C3 Instruction Manual

ID Mode

Multiple VC-C3s can be operated separately by assigning an ID number to each VC-
C3 and then specifying the desired ID number from the wireless controller.
If you install multiple VC-C3s in one location, all the VC-C3s will respond to the
commands from the wireless controller. In this situation, the ID mode function is
extremely useful as it permits the VC-C3s to be individually controlled.

Preparations

Set the ID numbers for each VC-C3.
ID selector
(Default setting)
Use a small flat-head screwdriver to set an
ID number (from 1 to 6) through the ID
selector on the rear panel of the base.
Set the ID numbers for each VC-C3s installed in
the location.
You can assign the same ID number to multiple
VC-C3s. In this way, the VC-C3s with the same ID
perform the same operation.
The numbers on the ID selector go up to 9, but
only numbers 1 to 6 are valid as ID numbers. If
you set the ID to 0 or 7 through 9, the VC-C3 will
respond to any wireless controller command and
cannot be controlled individually.
25