Selecting The Vc-C3 To Be Controlled - Canon VC-C3 Instruction Manual

ID Mode

Selecting the VC-C3 to be Controlled

When you select a specific VC-C3 to be controlled, only the selected VC-C3 will
respond to wireless controller commands.
26
1. Press the button.
The base LEDs on all the VC-C3s will blink
orange (at 0.5-second intervals).
To cancel the operation, press the button again.
2. Press a button from
The VC-C3s that have been set to that ID number
are now selected and the base LED turns to
green.
The LEDs on all other VC-C3s turn to orange, and
will not respond to any wireless controller
command other than the button.
This completes the selection of the VC-C3 to be
Check the VC-C3 base LEDs to ensure
that all the VC-C3s are receiving the
signals from the wireless controller.
VC-C3s that do not receive the commands
used in steps 1 and 2 will not operate
correctly.
controlled.
When any button other than is pressed, only the
selected VC-C3 will respond.
The base LEDs on the unselected VC-C3s blink
orange (at 0.5-second intervals) and those VC-C3s
do not operate.
to .