Installing The Seat - Toro 170-DH Installation Instructions

5
4
2
Figure 1
1. Center spoke
2. Shaft spline
3. Lock washer

Installing the Seat

1. Remove the plastic cover from the seat and discard it.
2. Loosen the two bolts on the tractor seat hinges.
3. Set the seat in place and secure it with the two bolts,
spring washers, and flat washers (Fig. 2).
4. Connect the safety switch to the seat (Fig. 2).
2
Figure 2
1. Safety switch
1
3
2307
4. Nut
5. Logo cover
1
2. Bolt and washers
Attaching the Trailer Hitch
1. Line up the holes in the trailer hitch with the holes in
the tractor frame.
2. Attach the hitch with two bolts, washers, and nuts
(Fig. 3).
3
Figure 3
1. Trailer hitch
2. Bolt
Assembling the Grass
Collector
1. Tilt the front tube of the partially assembled collector.
Align the upper holes with the holes on the upper tube.
Loosely fasten the tubes together with the upper bolts
(Fig. 4).
2. Place the collector on the rear tractor supports (refer to
the Operator's Manual, Installing the Grass Collector)
and align the collector frame with the tractor fenders.
Tighten the upper bolts (Fig. 4).
3. Stretch the bag and put it over the rear handle (Fig. 4).
4. Insert the bottom tube into the bag (Fig. 4).
2
1
2
3. Washer and nut