Brightness/Volume; Backlighttime Out - 2gig Technologies GO!CONTROL User Manual

Go!Control Wireless Security System | User Guide
that can chime and the option currently
set for the sensor.
To change the sensor's chime options,
press the sensor button.
There are 14 chime options for
TIP:
each sensor.
Check the option that you want for the
7
sensor, then press Ok.
When you are finished, press Back.
8
Chime
1 Disabled
2 Voice Only
3 Ding‐dong #1
4 Ding‐dong with
Voice #1
5 Ding‐dong #2
6 Ding‐dong with
Voice #2
7 Ding‐dong #3

BRIGHTNESS/VOLUME

You can adjust the brightness of the Control
Panel's display and the volume of the
system's speaker that is best suited to your
installed system.
To set the brightness and volume, do the
following:
From the Home Screen, press Security.
1
From the Security Screen, press Menu.
2
34 ©2013 2GIG Technologies Inc. All Rights Reserved.
Options
8 Ding‐dong with Voice #3
9 Ding‐ding
10 Ding‐ding with Voice
11 Chime#1
12 Chime with Voice #1
13 Chime#2
14 Chime with Voice #2
From the Menu Screen, press Toolbox.
3
Enter the Master User Code to access
4
the toolbox.
From the Toolbox Screen (1 of 3) press
5
Brightness/Volume. You can set the
brightness using the top bar. Adjust the
level from 1 to 12 using the buttons on
each end of the bar.
You can set the speaker volume for the
6
chimes and announcements on the
bottom bar. Adjust the level from 1 to 12
using the buttons on each end of the bar.
The volume setting does not effect the
7
alarm sounder volume.
When you are finished, press Ok.
8
BACKLIGHT TIME-OUT
The backlight time‐out sets the length of
time that the display stays lit after use. You
can adjust the backlight to 30 seconds, 1, 2,
5, or 10 minutes, or to always (to light the
display at all times).
NOTE: To conserve the Control Panel's
backup battery, during an AC power
failure, the display goes dark after 30
seconds regardless of this setting.
To set the display backlight time, do the
following:
From the Home Screen, press Security.
1
From the Security Screen, press Menu.
2
From the Menu Screen, press Toolbox.
3
To access the toolbox, enter a valid User
4
Code.
From Toolbox Screen (1 of 3), press the
5
→ arrow.