Table of Contents
Advertisement
Item
Network
Configure an IP
Address
Display
Subnet Mask
Display Name
Power Indicator Brightness Adjusts the brightness of the power indicator on the main unit. The greater the number is, the greater
Display Button LED
Fan Settings
Fan Control
Fan Stop
Compatible Settings
HDMI
Protect Settings
Password
70
OSD Menu
Setting Options (underline indicates factory default)
Configures settings for the network of the video display.
Note
• Setting is disabled when "Power on Setting" is set to "User 1-3".
Automatic: Configures an IP address automatically with DHCP/Automatic IP.
Manual: Configure an IP address and subnet mask manually.
192.168.0.1
255.255.255.0
Sets the name of the main unit. You can input up to 16 alphanumeric characters.
the brightness.
Off, 1 to 5 (3)
Sets the F buttons and the lamp on the face.
On, Off
Sets the operation of internal fan.
Fan noise can be eliminated when the main unit is used during shooting or when silent operation is
needed.
Set this in advance to stop the fan manually or to stop the fan (
REC signal. When this is set to "On", the mode changes so that the fan can be stopped.
On, Off
If "Fan Stop" is set to "On" and when "Fan Control" is set to "On", the fan can be stopped. At room
temperature (25 °C), the fan remains off for approximately one minute. The fan operates at a faster
speed than usual before and after the fan is stopped to lower the internal temperature.
On, Off
Note
• If the message "Invalid operation due to high temperature." is displayed, the fan cannot be
stopped even when "On" is selected for this item. Wait until the internal temperature lowers.
• If the temperature inside the main unit increases while the fan is off, the message "Fan will be
rotated as the temperature is high." is displayed and the fan starts rotating approximately ten
seconds later. Since the temperature of the main unit has increased, the fan rotates faster than
usual.
• Select "Off" to restart the fan. The fan rotates faster than usual.
• The fan may not stop in some conditions, for example when used at a high temperature.
Sets the connection compatibility with HDMI equipment.
Normal: All formats are supported.
Compatible 1: S et this option when video is not played correctly in "Normal". HDR signals of a
luminance higher than that of the display main unit are not supported.
Compatible 2: S et this option when video is not played correctly in "Normal" or "Compatible 1".
"4K50.00P/60.00P" and HDR signals are not supported.
Locks the settings so they cannot be changed. When you press the MENU button, "Signal/System
Information" appears, but other operations are grayed out because they are locked.
Set a password to protect settings. Use a four-digit number (0000 to 9999). The initial password is
blank.
68) by linking with the camera's
Advertisement
Table of Contents
