Flex State Parameters - GE C30 Instruction Manual

5 SETTINGS
LATCHED
From user-programmable
pushbuttons logic
sheet 1, 842021A3
LATCHED/SELF-RESET
PUSHBUTTON ON
SETTING
Message Priority
Instantaneous reset will be executed if any
front panel button is pressed or any new
target or message becomes active.
FLEXLOGIC OPERAND
PUSHBUTTON 1 ON
PUSHBUTTON 2 ON
PUSHBUTTON 3 ON
PUSHBUTTON 16 ON
The enhanced front panel has 16 operands;
the standard front panel has 12
Figure 5–12: USER-PROGRAMMABLE PUSHBUTTON LOGIC (Sheet 2 of 2)
User-programmable pushbuttons require a type HP or HQ faceplate. If an HP or HQ type faceplate was ordered
separately, the relay order code must be changed to indicate the correct faceplate option. This can be done via
EnerVista UR Setup with the Maintenance > Enable Pushbutton command.
NOTE

PATH: SETTINGS PRODUCT SETUP
 FLEX STATE
 PARAMETERS
MESSAGE
MESSAGE
MESSAGE
GE Multilin
AND
OR
AND
The message is temporarily removed if
any keypad button is pressed. Ten (10)
seconds of keypad inactivity restores
the message.
AND
= Disabled
= High Priority
= Normal
AND
FLEXLOGIC OPERAND
ANY PB ON
OR


FLEX STATE PARAMETERS

PARAMETER 1:
Off
PARAMETER 2:
Off
PARAMETER 3:
Off

PARAMETER 256:
Off
C30 Controller System
SETTING
Flash Message Time
0
T
RST
Instantaneous
reset *
OR
SETTING
Flash Message Time
0
T
RST
Instantaneous
reset *
PUSHBUTTON 1 LED LOGIC
1. If pushbutton 1 LED control is set to off.
FLEXLOGIC OPERAND
PUSHBUTTON 1 ON
2. If pushbutton 1 LED control is not set to off.
SETTING
PUSHBTN 1 LED CTL
= any FlexLogic operand
5.2.14 FLEX STATE PARAMETERS
Range: FlexLogic operand
Range: FlexLogic operand
Range: FlexLogic operand
Range: FlexLogic operand
5.2 PRODUCT SETUP
LCD MESSAGE
ENGAGE MESSAGE
SETTINGS
Top Text
= XXXXXXXXXX
On Text
= XXXXXXXXXX
FLEXLOGIC OPERAND
PUSHBUTTON 1 OFF
FLEXLOGIC OPERAND
PUSHBUTTON 1 ON
LCD MESSAGE
ENGAGE MESSAGE
SETTINGS
Top Text
= XXXXXXXXXX
On Text
= XXXXXXXXXX
5
Pushbutton 1
LED
Pushbutton 1
LED
842024A2.CDR
5-63