Program 14 : Trunk, Basic Setup; Basic Trunk Data Setup - NEC SL 1000 Programming Manual

SL1000/SL1100
Level:
IN
Description
Use Program 14-01 : Basic Trunk Data Setup to set the basic options for each trunk port. Refer to
Program
the chart below for a description of each option, its range and default setting.
14
Input Data
Item
No.
01 Trunk Name
02 Transmit Level
03 Receive Level
04 Transmit Gain
Level for Confer-
ence and Trans-
fer Calls
05 Receive Gain
Level for Confer-
ence and Trans-
fer Calls
06 SMDR Printout
07 Outgoing Calls
08 Toll Restriction
2-110

Program 14 : Trunk, Basic Setup

Trunk Port Number
Item Input Data
Up to 12 characters
1 ~ 63
(- 15.5 dB ~ + 15.5 dB
in 0.5 dB intervals)
1 ~ 63
(- 15.5 dB ~ + 15.5 dB
in 0.5 dB intervals)
1 ~ 63
(- 15.5 dB ~ + 15.5 dB
in 0.5 dB intervals)
1 ~ 63
(- 15.5 dB ~ + 15.5 dB
in 0.5 dB intervals)
0 = No (trunk will not be
reported in the SMDR
print out.)
1 = Yes (trunk will be
reported in the SMDR
print out.)
0 = Deny (No)
1 = Allow (Yes)
0 = Restriction Disa-
bled (Toll restriction will
not be applied to calls
on this trunk.)
1 = Restriction Enabled
(Toll restriction will be
applied to calls on this
trunk.)

14-01 : Basic Trunk Data Setup

001 ~ 126 (SL1000)
001 ~ 096 (SL1100)
Description
Set the names for trunks. The trunk
name displays on a multiline termi-
nal for incoming and outgoing calls.
Use this option to select the CODEC
gain for the trunk. The option sets
the gain (signal amplification) for the
trunk you are programming.
Use this option to select the CODEC
gain for the trunk. The option sets
the gain (signal amplification) for the
trunk you are programming.
Use this option to select the CODEC
gain type used by the trunk when it
is part of an Unsupervised Confer-
ence.
Use this option to select the CODEC
gain type used by the trunk when it
is part of an Unsupervised Confer-
ence.
This option can include/exclude
trunks from being reported in the
SMDR printout.
If a trunk is set to No Print Out (set-
ting data of 0) any calls made or re-
ceived on this line will not be repor-
ted in the SMDR printout.
Use this option to allow/prevent out-
going calls on the trunk you are pro-
gramming.
Use this option to enable/disabled
Toll Restriction for the trunk. If ena-
bled, the trunk follows Toll Restric-
tion programming (example: Pro-
grams 21-05, 21-06). If disabled, the
trunk is a toll free line.
Program 14 : Trunk, Basic Setup
ISSUE 3.01
Default Related
Program
Refer below
32 (0 dB)
32 (0 dB)
32 (0 dB)
16 (- 8 dB)
1
1
1 21-04
21-05
21-06