Processing Your Stl File; Printing Your Cmb File; Adding Your Cmb File To The Pack; Opening Your Cmb File With Control Center - Stratasys Fortus 250mc User Manual

PROCESSING YOUR STL FILE

To finish preprocessing the STL file with the default presets:
1. Click on the
the CMB file.
Note: Clicking on the Finish button will process the STL file with the default
processing presets. For more information on processing STL files, refer to
Dynamic Help or consult your local Reseller for Insight training.
2. Click on the

PRINTING YOUR CMB FILE

The Build Job button is found on the Pack tab.
Once build job settings have been accepted, the CMB file will open in the Control Center software.

ADDING YOUR CMB FILE TO THE PACK

The Insert CMB button is found on the Pack tab.
When you click on the Insert CMB button, Control Center will add the file that you select to the pack preview
window (Pack tab).

OPENING YOUR CMB FILE WITH CONTROL CENTER

1. Open the Control Center.
2. From the File menu select Open CMB...
3. Navigate to and select the CMB file that you have created.

INSERTING A MODELING BASE

Prior to inserting a modeling base into the tray, remove any material buildup on and behind the Z Platform and
around the lead screw. Failure to do so could cause the modeling base to be unlevel or, if the amount of buildup
is large enough, the Z Platform could jam at its upper limit.
Install the modeling base. See
Caution: DO NOT reuse modeling bases. If a modeling base is reused,
calibration errors, poor part quality, and loss of extrusion may occur. Additional
modeling bases are available from your reseller.
(Finish) button to finish all remaining preprocessing for the STL file and create
(Build) button to send the CMB file to the Control Center software.
"Insert Modeling Base" on page 21.
28