Alarm Descriptions; Alarm Occurrence - Panasonic WJ-SX650 Operating Instructions Manual

ALARM DESCRIPTIONS

■ Alarm Occurrence

When this unit accept an alarm input signal (terminal alarm, camera alarm, recorder alarm, serial alarm, or video loss), an
alarm event (tour sequence, etc.) is activated automatically. Each alarm input signal is associated with an alarm event setting.
(The setting activates the alarm input signal and alarm event.) Up to 1 024 alarm event settings are available. The alarm event
setting is performed in "Alarm" – "Alarm Event" of WJ-SX650 Series Administrator Console.
By performing the settings of "Alarm Event", the following events will be activated when this unit accepts an alarm input signal.
• Alarm event information will be displayed on the associated monitors (Refer to p.
• Depending on the setting of "Display
ciated monitors.
alarm mode is mentioned as alarm
• If a recorder is selected for "Recording Source
alarm setting and event recording setting of recorder. Refer to the operating instructions of recorder for details.)
• If an alarm output terminal is selected for "Alarm
The associated recorder can be notified of the alarm occurrence, and external alarm devices (buzzer, etc.) can be activat-
ed.
Notes:
• To activate terminal alarm output signals, perform settings of No.1 to 64. No.65 and greater are assigned for serial
commands.
• To activate serial alarm output signals, serial command settings are required. The settings are performed in
"Communication" – "Serial Command" of WJ-SX650 Series Administrator Console.
• ALARM indicators of all system controllers blink.
• Up to 10 000 alarm records are saved chronologically. The latest 1 000 alarm records can be displayed as the alarm his-
tory on the monitor. (Refer to p.
the unit.
• Alarm information is notified to the PC in serial commands. The serial command setting is performed in "Communication" –
"Serial Command" of WJ-SX650 Series Administrator Console.
Camera 100
Terminal alarm setting
No. Display Mode
256
66
Mode", camera images will be displayed, or sequences will be activated on the asso-
In this document, these actions are mentioned as the alarm mode, and pictures displayed during the
pictures.
33 Alarm History Display.) The Alarm History Display can be downloaded from the PC to
Preset Position 1
(Zooming in No.1 (Entrance))
N o. 10 (P ot )
N o. 11 (D is h)
Infrared sensor
LCN
SPOT 100
LCN", event recording will be activated. (Recording will follow the command
Output", alarm output signal will be supplied from the video output board.
This unit
650 650
Matrix Switcher WJ-SX
Terminal Alarm
256
Monitor 5
No.1 (Entrance)
Alarm input signal
from a sensor
Alarm Input 256
Sensor
system
Spot
Monitor
Preset
1
16 Monitor Display Information.)
Alarm Output 50
Records the image
of Camera 10.
(Recording follows
the command alarm
setting and event
recording setting of
recorder.)
STOP PLAY PAUSE REC - REC STOP
MONITOR1 PULL
MONITOR2 REV FWD
TIMER 1 2 3 4
ALARM ERROR PAN/ TILT GOTO LAST SEARCH
SHIFT SEQ OSD
5 6 7 8 PAN/TILT SETUP
ALARM ZOOM/ A-B SLOW /ESC
SUSPEND ALARM FOCUS REPEAT — +
RESET DISK SELECT COPY TEXT MARK
9 10/0 11 12 IRIS LISTED
HDD 1
OPERATE EL-ZOOM LOGOUT PRESET
13 14 15 16 /AUTO Digital Disk Recorder
HDD 2 SET
BUSY
WJ-HD
Recorder 10
Notifies the
PC
alarm event
occurrence.
Recording
Source (LCN)
5 10
Alarm Output
50