Tour Sequence; Group Sequence/Preset - Panasonic WJ-SX650 Operating Instructions Manual

■ Tour Sequence

● WV-CU950/650
1. Enter the desired sequence number by pressing the
numeric buttons. The entered number will appear on
the LCD.
2. Press the TOUR SEQ button. The tour sequence will be
activated.
● WV-CU360C/CJ
1. Enter the desired sequence number by pressing the
numeric buttons. The entered number will appear on
the LCD.
2. Press the SEQUENCE button. The tour sequence will be
activated.
64

■ Group Sequence/Preset

● WV-CU950/650
1. Select a monitor assigned
sequence/preset. (Refer to p.
2. Enter the desired sequence number by pressing the
numeric buttons. The entered number will appear on
the LCD.
3. Press the GROUP SEQ button while holding down the
SHIFT button. The group sequence will be activated.
● WV-CU360C/CJ
1. Select a monitor assigned
sequence/preset. (Refer to p.
2. Enter the desired sequence number by pressing the
numeric buttons. The entered number will appear on
the LCD.
3. Press the GROUP SEQ button. The group sequence will
be activated.
● Notes:
• If you have specified Group Sequence 9 to 32 in Step
2, group preset will be activated. The system status will
be the same as that after camera selection.
• Group sequence/preset will not be activated for moni-
tors selected by operators with higher priority or
restricted by the monitor access setting
• When a monitor assigned for the active group
sequence is controlled by a higher-level operator, you
cannot control the monitor. (Monitor busy)
for desired group
21 Monitor Selection.)
for desired group
21 Monitor Selection.)