Spring Clamp Terminal Block - Mitsubishi Electric MELSEC Q Series User Manual

5
SETTINGS AND PROCEDURES BEFORE
OPERATION
5.4.2
(1) Method for connecting a cable to the spring clamp terminal block
Figure 5.14 Connecting a cable to module power supply/safety power supply part/safety input part/safety output part terminal block
Figure 5.15 Connecting a cable to extension communication part terminal block
5
- 25 5.4 Wiring

5.4.2 Spring clamp terminal block

Spring clamp terminal block
(a) Connecting a cable
1) For module power supply part/safety power supply part/safety input part/safety
output part terminal block
While pressing the open/close button with a flathead screwdriver, insert a
cable into the insertion hole.
For use of bar terminals, the cable can be inserted without pressing the open/
close button.
Open/close button
Insertion hole
2) For extension communication part terminal block
Insert a flathead screwdriver into a ditch between the insertion holes, and
insert a cable into the hole while pressing the driver.
For use of bar terminals, the cable can be inserted without pressing the open/
close button.
Open/close button
Insertion hole
Flathead screwdriver
Flathead screwdriver