Mitsubishi Electric MELSEC Q Series User Manual page 58

5
SETTINGS AND PROCEDURES BEFORE
OPERATION
Number
4) Start-up part terminal block
5) Safety output part terminal block
Extension communication
6)
station number setting switch
Extension communication
7) terminating resistor setting
switch
8) Start-up mode setting switch
9) Safety part extension connector IN, OUT
10) Serial number display
Table 5.3 Part names (2/2)
Name
XS XS0, XS1: Start-up/off, check terminal
Z00, Z01: Safety relay output terminal
Z10, Z11: Safety relay output terminal
Z20, Z21: Safety relay output terminal
A switch for setting the station number of extension communication
LOCAL ST No.
Switch 1: Reserved
Switch 2
LT
ON: Terminating resistor is attached.
OFF: Terminating resistor is not attached.
A switch for setting start-up input mode
"A" side: Auto mode
"M" side: Manual mode
A connector for connecting an extension module
IN: A connector for connecting a module to the previous module with safety
part extension cable at extension
OUT: A connector for connecting a module to the next module with safety part
extension cable at extension
A serial number same as the one shown on the rating plate
Description
Setting switch status (LOCAL ST No.)
Setting
8 4
1 OFF OFF
2 OFF OFF
3 OFF OFF
Set a station number within the range from 1 to 3.
Setting 4 or later may cause an error.
5.3 Extension Safety Relay Module
5.3.3 Part names and settings
2 1
OFF ON
ON OFF
ON ON
5
- 16
1
2
3
4
5
6