Analogue Operator Interface Connector (Model 25 Only) - Philips SOPHO SuperVisor 25 Engineer's Manual

Receive +
Transmit +
Not Connected
Figure 6-5 S Bus Interface Connector.
0
Note: Here an S
network side a RJ45 connector. The standard cable for ISDN interface is a cable with at
both sides a RJ45 plug and it cannot be used for this purpose!
6.4. ANALOGUE OPERATOR INTERFACE CONNECTOR (Model 25
Only)
If the Analogue Operator Interface is used for Model 25, it is connected to the ISPBX with a
2x8 wire cable. A special cable is provided to connect the console to the interface in the ISPBX
or to the Connection Box (see chapter
power is supplied together with data and voice. (The data part of the interface exchanges
information between the operator and the ISPBX.) The interface connector is a F122
connector. It allows a direct connection with the connector on the analogue operator
interface board in the ISPBX.
In Figure 6-2 "Items at the Rear Side of Model 25."
in Figure 6-6 "Analogue Operator Interface Signals on F122 Connector at Model 25."
layout.
50
Receive -
Transmit-
Not Connected
1 6
bus cable is required with at the SuperVisor side a RJ12 connector and at the
0
2. "INSTALLATION"). Via this interface the 48 V DC
the location of this connector is shown and
the pin