Philips SOPHO SuperVisor 25 Engineer's Manual page 16

SYSTEM TYPE
TBX
SOPHO-S50/100
SOPHO-S250/1000
(PR63x and 64x only)
SOPHO-S250/1000
(SSW 300 and SSW 805 only)
SOPHO iS3070 with PM2500
SOPHO iS3000 series
Table 2-1 Interface Boards in ISPBX for Model 25-A.
Execute the following steps to install the hardware:
- Connect the console to the appropriate interface board in the ISPBX according to
2-1 "Connection between ISPBX and Model
circuits in the ISPBX, check which circuit is to be used. If more information is required on
the interface connections, consult the ISPBX documentation.
- Check that a dummy connector is installed in the S
console. If not, install a dummy connector in the S
required for safety reasons.
A special cable is required to connect the console to either the interface board or to the
connector box. The connector box is required if the cable length of the special cable is not
sufficient. By using a connector box the cable length can be increased to up to 300 meters.
Consult also the Installation Manual or Customer Engineer Manual of your system for more
information on connecting an analogue operator console.
CAUTION:
14
DO NOT PLUG THE F122 INTERFACE CONNECTOR UPSIDE
DOWN INTO THE CONSOLE. IF THE CONNECTOR IS PLUGGED
INTERFACE BOARD FOR MODEL 25-A
MSU (Miscellaneous Unit)
ADU (Alarm and Distribution Unit)
UMI (Universal Miscellaneous Interface)
AOC (Analogue Operator Circuit) on PMC
board
OIU (Operator Interface Unit
AOC (Analogue Operator Circuit) on PMC
board
25-A.". If there are more than one operator
bus interface connector on the
0
bus interface. This connector is
0
Figure