NEC D3 Quick Start Manual page 26

5. At the Disk Array Selection window,
select the array to be initialized, and then
click Next.
Note: To be initialized, an array must be
in the Not Initialized state. Arrays in a
Suspended or Finished state have
already been initialized and should be
configured by using the steps outlined in
the Configuring Logical Disks and Pools
section on page 35.
Note: The wizard will only initialize one
array at a time. If multiple arrays are
selected, the wizard will initialize the first
array and then restart the initialization
process for subsequent arrays until all
selected arrays have been initialized.
6. After selecting the array, a confirmation
window will appear. Confirm that the
correct array was selected and click Yes
to continue. Otherwise, click No to go
back and then select the correct array.
7. The Disk Array Connection State
Confirmation window displays an
example of how an array should be
cabled. Verify that the array is cabled
correctly and click Next, or click Cancel
if there is a problem with your array's
connections.
Note: This screen shows a fully
configured array only. It does not show
your specific configuration.
NEC D3/D4 Quick Start Guide 24