Application Server Installation - NEC D3 Quick Start Manual

11. At this point, the installation process has been
completed and a system restart will be required
before starting Storage Manager for the first
time. Either click Finish to close the Storage
Manager Setup and restart the server, or if you
do not want to restart the server at this time,
select Restart later and then click Finish.
12. After the management server has restarted, the
Setup Complete window will appear. Clicking
Finish will launch a Web browser window that
will prompt for a login and then launch the
initialization wizard for the array.
Clicking Cancel will still finish the installation but
will not open a browser window and initialize the
array.

Application Server Installation

After installing software on the management server, the application servers need to be prepared to connect to
the array by installing an auto-discovery host agent on the application servers.
The auto-discovery host agent allows you to perform an auto-discovery of hosts during the array initialization
process when binding logical drives. This host agent can either be installed as part of iSM Volume List
Command or Command Control.
The iSM Volume List installation (shown below) provides basic host server functionality. The Command Control
installation provides advanced features that are necessary when using the advanced software functions of the
array. For information about how to install Command Control, please refer to the NEC Storage Manager
Manuals section on the Storage Manager CD.
The following steps outline the process to install the iSM volume list host agent and configure the application
servers to connect with the array through a Fibre Channel connection.
NEC D3/D4 Quick Start Guide 16