Disabled And Dhcp Server; Routing - Frontier fios User Manual

Disabled and DHCP Server.

To set up the Gateway's network bridge to function as a DHCP server:
In the IP Address Distribution section, select the DHCP server. Once
1.
enabled, the DHCP server provides automatic IP assignments (also
referred to as IP leases) based on the preset IP range defined below.
• Start IP Address – Enter the first IP address in the IP range that the
Gateway will automatically begin assigning IP addresses from. Since
your Gateway's IP address is 192.168.1.1, the default Start IP Address is
192.168.1.2.
• End IP Address – Enter the last IP address in the IP range that the
Gateway will automatically stop the IP address allocation at. The
maximum end IP address range that can be entered is 192.168.1.254.
If Windows Internet Naming Service (WINS) is being used, enter the
2.
WINS server address.
In the Lease Time in Minutes field, enter the amount of time a
3.
network device is allowed to connect to the Gateway with its
currently issued dynamic IP address.
Click Apply to save changes.
4.

ROUTING

You can configure your Gateway to use static or dynamic routing.
• Static routing – specifies a fixed routing path to neighboring
destinations based on predetermined metrics.
• Dynamic routing – automatically adjusts how packets travel on the
network. The path determination is based on network/device
Copyright © 2016 Frontier Communications. All Rights Reserved.