Specifications - Mitsubishi Electric CC-Link User Manual

3 SPECIFICATIONS

3 SPECIFICATIONS
Item
Operating ambient
temperature
Storage ambient
temperature
Operating ambient
3 humidity
Storage ambient
humidity
Vibration
resistance
Shock resistance
Operating
environment
Operating height
Installation area
Over-voltage
1
category
2
Pollution rate
1 Indicates the location where the device is connected from the public cable network to the
device structure wiring area.
Category II applies to the devices to which the power is supplied from a fixed equipment.
Surge withstand voltage for devices with up to 300 V of rated voltage is 2500 V.
2 This is an index which indicates the degree of conductive object generation in the
environment Pollution level 2 is when only non-conductive pollution occurs.
A temporary conductivity caused by condensation must be expected occasionally.
3 Do not use or store the PLC in the environment where the pressure is higher than the
atmospheric pressure at sea level. Otherwise, malfunction may result. To use the PLC in
high-pressure environment, contact your nearest Mitsubishi representative.
3 - 1
This section explains the CC-Link embedded I/O adapter general specifications.
Table 3.1 General specifications
When there is
Conforming
intermittent
to JIS B
vibration
3502, IEC
When there is
61132-2
continuous
vibration
Conforming to JIS B 3502, IEC 61131-2 (147 m/s
Specifications
0 to 55 °C
-20 to 75 °C
10 to 90 % RH, No condensation
10 to 90 % RH, No condensation
Frequency Acceleration
10 to 57 Hz —
2
57 to 150 Hz 9.8 m/s
10 to 57 Hz —
2
57 to 150 Hz 4.9 m/s
2
, 3 times each in 3 directions)
No corrosive gas present
2000 m(6562 ft) or less
On the control board
II or less
2 or less
MELSEC-A
Amplitude Sweep Count
0.075 mm
10 times
—
each in X, Y
and Z axis
0.035 mm
(80 minutes)
—
3
3 - 1