After selecting "OK" the network "GE" should show up under Networks and by selecting the Network, the main configuration page will be shown.
4
In this menu the following settings have to be made:
Menu
Model Family
Model Utilities
IP address configuration
Ethernet Configuration
In the IP Configuration tab, the "Configured" bottom has to be selected, and the IP address and Subnetwork mask has to be filed out. In this example the address
192.168.1.20 is used as the address for the master.
The step assigns the protocol to the scanner, which is done by selecting the scanner and selecting the "Function" menu and enables the Ethernet by selecting "ETH
TCP IP" This brings up the Net Link menu, where "GE" has to be selected. At this time the "GE" Protocol is assign to the Scanner and the last step is to configure the
scanner to read and write holding registers of the AF-650 GP.